PI66 Injection Molded Valve Body Fittings

Chang'an Town PI66 Injection Molding Parts Mold Design Shantou PPA Plastic Parts Manufacturer
Dongguan Dinghao Plastic Technology Co., Ltd. adheres to the business philosophy of "Dedication Creates Excellence, Focus Builds Brands, and Devotion Fosters Innovation," upholding the corporate spirit of "Integrity and Collaboration, Serving Customers, Unity and Progress, Striving for Efficiency." We work hand in hand with friends from all walks of life for mutual benefit, shared development, and共创辉煌.


Name: Valve Body
Model: MPT-00326
Length: 80±0.5mm
Width: 55±0.5mm
Height: 30±0.5mm
Large Diameter: 26±0.5mm
Small Diameter: 10±0.5mm
Material: PI66+GF
Color: Yellow
Weight: 33g
Note: The above data is for reference only,
Please refer to the actual product,
Customization available based on provided drawings or samples

Four Common Problems and Solutions in Plastic Mold Forming
Problem One: Scorching Scorching is the premature vulcanization of plastic, where poor mold flow causes deformation or incomplete parts before the plastic flow is complete. To prevent or eliminate scorching, ensure the mold is fully filled before vulcanization begins and that the mold cavity is evenly heated.
Problem Two: Backflow This is the deformation of molded products at the mold parting line, often appearing as tears or rugged indentations. Backflow is usually caused by the sudden release of internal pressure when the mold opens. To prevent it, avoid rough or excessive openings at the parting line and maintain the molding temperature as low as possible with the vulcanizing agent used.
Problem Three: Entrapped Air Air trapped in the plastic mold or plastic can cause soft, discolored areas on the surface or cross-section of molded parts due to incomplete vulcanization. Solutions include: 1. Colliding the mold. 2. Increasing the amount of vulcanizing agent. 3. Using high-temperature vulcanizing agents with lower air reactivity. 4. Venting at sharp corners and undercuts of the mold.
Problem Four: Surface Discoloration This is often due to excessive buildup of release agent in the plastic mold cavity or too much dust or dirt in the preform. To prevent such issues, clean the mold regularly, keep preforms clean, and use release agents cautiously.