Babbitt alloy bearing bush

Production of Babbitt alloy, bearing alloy, Babbitt bearing shells, support pads, bushings, and liners. We sincerely look forward to cooperating with you to achieve brilliance together. Below, I will briefly discuss the relevant knowledge of Babbitt bearing shell pouring for consumers: 1. Cleaning of alloy bearing shells: Place the bearing shells in a 10%-15% cleaning agent 1 solution to remove rust, then place them in hot water at 80 degrees Celsius to eliminate remaining dirt. After washing, place the bearing shells in hot water at 70 degrees Celsius to rinse off any remaining impurities. After cleaning, avoid touching the inner surface of the bearing shells with your hands. Sometimes, due to prolonged storage after removing the old alloy, an oxide layer may form on the surface. Before tinning, perform a 3-minute weak corrosion with cleaning agent solution, then immediately immerse in cleaning agent 2 solution for 2 minutes to neutralize, followed by rinsing with hot water. 2. The adhesion of tin to the bearing shell is better than that of Babbitt alloy. Tinning helps the Babbitt alloy adhere more firmly. The tinning material used is tin or tin alloy, along with a flux. The flux removes surface oxides and grease, ensuring a strong bond. Tinning methods include the wiping method and the dipping method. 3. Decontamination: Use a blowtorch flame or heating furnace to heat the back of the bearing shell to remove the old Babbitt alloy. Carefully clean the melted Babbitt alloy from the bearing shell with a steel brush, removing dirt, rust, and traces of Babbitt alloy. Pay special attention to cleaning the oil grooves and dovetail slots. After cleaning, tinning is applied as a base layer before pouring the Babbitt alloy solution...