GYZ450×84(CR) Circular Bridge Laminated Rubber Bearing - Inquiries and orders are welcome.

GYZ450×84(CR) Circular Bridge Laminated Rubber Bearing - Inquiries and orders are welcome

Product Introduction and Construction Guide for GYZ450×84 Laminated Rubber Bearing

1. Introduction to GYZ450×84 Laminated Rubber Bearing

GYZ450×84 is a circular laminated rubber bearing suitable for small and medium-span bridges and building structures, featuring cushioning and shock absorption, deformation adaptability, and easy installation.

Main Features:

• Structural Composition: Made by vulcanizing multiple layers of rubber and steel plates, with rubber layers providing elasticity and steel plates enhancing compressive strength.
• Specifications and Models:
• GYZ: Circular laminated rubber bearing (G stands for highway bridges, YZ stands for circular bearing).
• 450×84: Diameter 450mm, total thickness 84mm (specific thickness may vary slightly by manufacturer).
• Load Capacity: Typically suitable for vertical load capacity of 500~2000kN (specific parameters should be checked with the manufacturer).
• Displacement Adaptation: Can accommodate horizontal displacement of the beam (generally ≤5–10mm) and minor rotations (0.01–0.02rad).
• Durability: Rubber is made of chloroprene rubber (CR) or natural rubber (NR), offering aging and corrosion resistance.

Applicable Standards:

• JT/T 4-2019 "Laminated Rubber Bearings for Highway Bridges"
• GB 20688.4-2007 "Rubber Bearings - Part 4: General Rubber Bearings"

2. Construction Steps for GYZ450×84 Laminated Rubber Bearing

(1) Pre-Construction Preparation

• Check Bearing Quality:

• No cracks or bubbles in the rubber, no rust or delamination in the steel plates.

  • Verify specifications (diameter 450mm, thickness 84mm) and load capacity to ensure they meet design requirements.

• Check Support Pad Stones:

• Pad stone concrete strength ≥ C40, surface flatness (level deviation ≤ 2mm).

• Clean the pad stone surface to ensure no oil stains or floating slurry.

  • Measurement and Positioning:

• Use a total station or steel tape for layout to ensure the centerline of the bearing aligns with the beam axis.

  (2) Bearing Installation

1. Temporarily Fix the Bearing:

• Apply epoxy resin or specialized adhesive on the pad stone (if bonding is required by design).

  • Gently place the bearing to avoid impact and ensure close contact with the pad stone.

  2. Beam Installation:

• Slowly lower the beam during hoisting to avoid eccentric compression.

  • Check if the bearing is uniformly loaded with no local voids (use a feeler gauge to detect gaps ≤ 0.3mm).