Experimental Teaching Twin-Screw Extruder Production Line

Find Dongguan Jiutong Machinery Co., Ltd.

Address: *2 Industrial Zone, Guchong Community, Wanjiang District, Dongguan City

Contact Person: 138-2574-4148

Our factory supplies instruments for rubber and plastic laboratories: mixing mills, platen vulcanizing machines/hot presses, internal mixers, single-screw/twin-screw mixing and compounding extruders and pelletizers, blown film machines/cast film machines/calenders/sheet extruders/profile extrusion lines/micro compounding and spinning lines/3D consumable lines/pipe extrusion lines, etc..Small-scale prototyping sold to universities, research institutions, and factory laboratories for application.

Experimental teaching twin-screw testing machine production linePurposeBatch sizeOne formula can process1-3KG; continuous extrusion 8-10KG/H; used for material modification; reinforcement; filling; masterbatch, etc., for formula development.

SHJ-20 Twin-Screw Compounding Extruder Parameters:

A. SHJ-20 Twin-Screw Extruder L/D ratio 40:1; Feeder 0.75KW;

1. Gear Reduction Box

1)Reduction Ratio: 3:1

2)Output Shaft Speed: 0~500rpm

3)Input Shaft Speed: Max 1500rpm

4)Main drive box integrates reduction and torque distribution, adopting a compact parallel three-shaft design. Reduction, torque distribution, and radial bearings of the two output shafts all use NSK bearings.

2. Main Motor

1)Main Motor: 4KW (AC motor)

2)Motor Speed (MAX): 1500RPM

3. Screw

1)Screw Diameter: Φ21.7mm

2)L/D=40:1

3)Screw core shaft made of 40CrNiMoA material, thread elements and core shaft connected by involute spline, high strength, high load capacity, easy disassembly and assembly.

4)Screw elements made of 38CrMoAlA nitrided steel, fully nitrided, surface hard chrome plated (roughness grade 10).

5)Overall hardness approx. HRC65~75.

4. Plastic Extruder Barrel

1)Barrel material uses premium 38CrMoAlA nitrided steel, fully nitrided, surface hard chrome plated (roughness grade 10). Hardness approx. HRC65-75, barrel length L=120mm/section;

2)One barrel section is the feed section, three sections are reserved for auxiliary feeding, the sixth section is the venting section, the seventh section is the extrusion section, the remaining sections are closed barrels.

3)Soft water circulation system

5. Heating (Omitted) Uses melt temperature thermocouples specifically for measuring material melt temperature, uses pressure sensors specifically for measuring material pressure.

6. Vacuum Degassing Device

7. Screen Changer Die Hinged quick-open water-cooled strand die

8. Cantilever Type 20 Pelletizer

9. Control