CEN16165-DIN51097-DIN51130 Ramp Test Method Anti-Slip Tester

Complies with standards:
DIN-51097, DRAFT EN ISO 10545-17 ANNEX C, UNI CEN/TS 16165:2012 (E), DIN 51130:2014-02

This equipment is used for type testing of the anti-slip performance of escalator and moving walk steps, pedal treads, comb support plates, and floor plate surfaces; it consists of a non-distorting 600mm wide by 2000mm long flat plate serving as a simulated inclined platform, with longitudinal slope adjustable between 0° and 45°. The inclined plane anti-slip tester is available in both imported and domestic options.
A servo motor drives the platform to rotate at a specified angular speed via a lead screw mechanism. Under the operator's control, the angle is gradually changed in 0.50° increments. Before testing, lubricant is applied to the test surface and the test shoe sole. The operator, wearing protective gear, maintains an upright posture and walks back and forth on the test platform in half-shoe steps along the observation direction. The test platform begins to tilt from the horizontal position at a rate of 1°/s. When the tilt angle reaches the critical point, tilting stops, and the angle value is recorded. This is repeated three times to ensure accuracy of the angle values.

Dynamic Critical Angle Anti-Slip Category
≥6 <10 R9
≥10 <19 R10
≥19 <27 R11
≥27 <35 R12
≥35 R13

Technical Specifications:
1. Controlled by electromechanical brake movement.
2. Start/stop control operation via buttons on the hanging panel.
3. Controlled by digital tilt meter with an accuracy of ±0.1°.
4. Working angle range: 0° to 45° according to standards.
5. Speed: 1° per second.
6. Supply: 230 V - 50/60 Hz single phase.

Accessories and Spare Parts:
1. No. 42 shoes according to DIN51130 and CEN16165 standards.
2. A set of ST-A, ST-B, ST-C; ST-I, ST-II, ST-IIIA test plates according to DIN51097, DIN51130, and CEN16165.