Frequency 5-50Hz Landing Gear Shimmy Characteristic Simulation Test Bench

Aircraft Landing Gear Shimmy Test DeviceLanding Gear Shimmy Characteristic Simulation Test Bench

Landing GearShimmy Damper Damping Performance TestLanding Gear Taxiing Shimmy Test System

Tire Characteristic Test Under Static/Rolling ConditionsLanding Gear Shimmy Dynamics Test Device

I. Equipment Introduction

The aircraft landing gear shimmy test device is primarily used to simulate the dynamic characteristics of the landing gear system during aircraft taxiing, takeoff, and landing. By precisely testing the dynamic response of aviation tires and landing gear under disturbance excitation, it provides critical data support for aircraft design and airworthiness certification.

Test Principle:

The landing gear shimmy test is based on recording and analyzing the response of the landing gear after applying transient initial disturbances under simulated aircraft taxiing conditions, verifying the shimmy stability of the landing gear.

Execution Standards:

HB 7584-1998 "Terminology for Aircraft Landing Gear System"

HB 8681-2021 "General Requirements for Aircraft Landing Gear Shimmy Tests"

HB-7666 "Performance Test Verification Requirements for Landing Gear Systems"

II. Main Technical Parameters

Simulated taxiing speed: 0-300 km/h, supports continuous adjustment;

Shimmy frequency range: 5-50 Hz;

Load Capacity

Vertical load: 0-500 kN;

Lateral load: 0-50 kN;

Vibration Displacement Range

Axle swing angle: ±5°;

Vertical displacement: ±100 mm;

Control and Measurement Accuracy

Speed control accuracy: ±1% FS;

Swing angle measurement accuracy: ±0.05°;

Load measurement accuracy: ±1% FS;

Sampling frequency: ≥10 kHz;

Shimmy damper testing capability

Supports damping characteristic testing of hydraulic/mechanical shimmy dampers, with adjustable damper oil pressure (0-20 MPa) and damping coefficient (0-100 kN·s/m);