Aluminum Product Trimming Machine / Rapid Four-Column Hydraulic Press

Manufacturer Recommendation】Aluminum Product Trimming Machine &Ningbo Aluminum Product Trimming Machine% Aluminum Product Trimming Machine Manufacturer.Contact Person: Yang LongshengPhone:13586712382

Application Range of Aluminum Product Trimming Machine: (Die-casting Product Trimming Machine, Hydraulic Press, Oil Press, Die-casting Product Punching Machine, Hydraulic Trimming Machine, Trimming Machine, Aluminum Product Punching Machine, Aluminum-Magnesium Product Trimming Machine)
This series of aluminum product trimming machines is used for deburring and shaping various aluminum and magnesium alloy die-cast products, as well as trimming plastic products. The aluminum product trimming machine is also suitable for forming plastic materials, such as blanking and stretching of sheet materials. It is an upgraded product of the TH106 standard model, adopting an advanced master-slave cylinder hydraulic circuit. Whether in terms of noise, speed, or power consumption, it outperforms ordinary hydraulic presses. It is a new generation of hydraulic press with high efficiency, high speed, high output, and high environmental protection. This machine is widely used in the die-casting industry.
Product Features of Aluminum Product Trimming Machine:
1. This series of aluminum product trimming machines uses a liquid pressure of 2-20 MPa as the power source, connected to a three-phase AC380V 50Hz or three-phase AC220V 60Hz power supply.
2. This series of aluminum product trimming machines uses liquid as the medium to transmit energy, adopting an advanced master-slave cylinder hydraulic circuit. The oil temperature is low, with an idle speed of over 150 mm/s and a working speed below 30 mm/s.
3. The noise level during standby and when the slide moves up and down does not exceed 75 decibels.
4. It adopts a four-column three-plate structure, with the vertical accuracy of the moving plate controlled by four precision guide sleeves. The parallel accuracy between any point on the lower working surface and the upper working surface is within 0.1 mm.
5. The press is equipped with a waste blowing device and has a waste discharge chute in the center of the lower worktable.
6. The lower stopping point of the press is generally controlled by a pressure switch and position sensor.
7. The aluminum product trimming machine has an automatic counting function, with manual and semi-automatic control modes. The manual mode allows the upper die to stop at any point within the stroke range. It is equipped with an emergency retraction button and can also be fitted with an infrared hand protection device.
8. The pressure, stroke, trimming speed, blowing time, and closed height of the aluminum product trimming machine can be adjusted by the customer for convenient operation.
9. The hydraulic system is built into the bottom of the fuel tank, giving it a neat and stable appearance.
10. The output force range of this series of aluminum product trimming machines is 15 tf to 200 tf (1 tf = 1000 kgf = 9.8 kN).