HM Multi-Model SSI Signal Conversion Instrument Industrial Grade EJ

Operating Parameters

Input signal: Absolute encoder synchronous serial SSI signal, Gray code or binary (single-turn 10-24 bit, multi-turn 24-25 bit, or 10-24 bit linear sensor, specify when ordering, other bit lengths can be customized).

1 external reset switch signal, which can set zero position or preset position when input.

* Operating voltage: 220Vac (24Vdc available upon request)

* Output type: One 4-20mA analog output. D/A output accuracy 12-bit.

One RS485 full digital output, with built-in communication protocol, can also be customized according to customer requirements.

2~4 preset position outputs. Relay dry contacts, 2 switches are NO+NC, others are NO or NC

(range alarm optional when ordering).

* Ambient temperature: -10℃～60℃

* Relative humidity: <90%

* Transmission distance: Sensor to instrument connection distance is 100 meters (specify when ordering for distances over 100 meters, maximum not exceeding 250 meters)

Recommended cable: FK032014 (for long distances over 50 meters)

Output signal transmission distance is 1000 meters (4-20mA transmission cable total impedance less than 400 ohms).

Function Settings:

* Digital display: 6-digit digital display, decimal point position can be set.

* Zero setting: Zero or specified position can be set at any location. Can be set via panel or external switch.

* Stroke length setting: Total length setting for linear encoder.

* Direction setting: Encoder forward/reverse direction setting.

* Analog output: 4-20mA output corresponding value setting; analog zero and full scale calibration.

* RS485 output: RS485 output, address and baud rate setting, communication protocol can also be customized according to customer requirements.

* Switch setting: Multiple preset switch panel settings, sensitivity setting, switch type setting.

* Nonlinear setting: 16-segment nonlinear setting or field calibration, can be used for hoist layering, arc gate setting.

* Remote display: Output signal can go to PLC for one channel, and to remote display instrument for another channel.