Cable and Wire Compound Carbon Black Content Tester

Wire and Cable Pellet Carbon Black Content Tester complies with GB/T3515-2005 "Determination of Carbon Black Content in Rubber - Pyrolysis Method", GB/T13021-1991 "Determination of Carbon Black Content in Polyethylene Pipes and Fittings (Thermogravimetric Method)", GB/T 7876-87 "Determination of Loss on Ignition in Forest Soils", and YDT 837.3-1996 "Test Methods for Copper Core Polyolefin Insulated Aluminum-Plastic Composite Sheathed Local Communication Cables - Part 3: Mechanical and Physical Performance Test Methods". The instrument features ease of use, simple operation, accurate measurement, high precision, and a high degree of automation.

I. Main Features of the Wire and Cable Pellet Carbon Black Content Tester

1. The instrument has an aesthetically pleasing exterior structure and is simple to operate;

2. High degree of automation: simply set the temperature value and heating time, and the instrument automatically heats up to the set value;

3. High temperature control precision, wide temperature range, and high uniformity of furnace temperature;

4. Equipped with a constant temperature function, and the constant temperature time can be set;

5. The instrument can be set for 30 different heating stages, each with different heating temperatures, heating rates, and constant temperature times;

II. Main Technical Parameters

III. Structural Advantages

The furnace shell of the Wire and Cable Pellet Carbon Black Content Tester is made of thin steel plate folded and welded, with the inner furnace lining being a rectangular monolithic lining assembled from ceramic fiber material. The heating elements, formed into a spiral shape, are threaded through the inner furnace lining. The furnace interior is a sealed structure, with an air insulation layer between the inner furnace and the furnace shell.

The combustion tube can be directly inserted or removed from the inner furnace. High-temperature resistant silicone plugs are equipped with quartz glass inlet tubes. Gas is introduced according to standards via the gas three-way directional valve and gas flow meter on the control panel. This device adopts an integrated structure. After purchase, users can directly connect to the power supply to begin furnace baking.

IV. Installation and Use

1. No special installation is required; it can be placed on a flat indoor floor or workbench (rack). To ensure safe operation, the electric furnace and its外壳 must be reliably grounded.

2. The back of the electric furnace is equipped with gas inlet and outlet devices, allowing for the introduction of nitrogen, air, or mixed gases. Connecting pipes and three-way valves must be used, and gas cylinders must be placed at least 4 meters away from the furnace. Gas cylinders must be equipped with pressure reducing valves, and the hoses connecting the gas cylinders to the carbon black tester should be pressure-resistant rubber hoses.

3. When the furnace temperature begins to rise, open the main valve of the nitrogen or mixed gas cylinder, adjust the pressure reducing valve to the minimum pressure, and open the valve on the control panel of the carbon black tester (pay attention to the direction). Introduce gas into the combustion tube at a flow rate of 2L/min. After the experiment is completed, close the main valve of the gas cylinder. After verifying that all connections are correct, proceed to power on and heat up.